SEC 02 // PART RECORD
277222 Miller Flow Meter (Face Shield PAPR)
Fits these systems
| System | Compatibility status | Evidence |
|---|---|---|
| Miller Face Shield PAPR | T2 Manufacturer-listed part |
|
Specifications
| Function | Disconnect breathing tube from hood, insert flowmeter into breathing tube, hold straight up, and start blower; air flow is adequate if the flowmeter ball moves above the MIN mark (Section 6-8) |
|---|---|
| Test interval | Always test air flow before using the respirator; also check monthly if not used regularly (Section 6-8) |
STOCKED BY — SUPPLIER CROSS-REFERENCE
Stocked by
- Baker's Gas & Welding Supplies US
- Cyberweld US
- Welder Supply US
- Weldfabulous US
- Weldready CA
- Welding Supplies from IOC US
No listed suppliers for this region — see the supplier directory.
See the full supplier directory for all regions and evidence notes.
Listing ≠ endorsement. Confirm availability, approval status and source evidence before purchase or regulated workplace use.
Record sources
Evidence — dated sources
- [01] www.millerwelds.com manufacturer manual OM-288359A Section 6-8 (p.20) and Section 10 (p.31). 2026-07-06